Notebook Pinball: lesson plan
Pupils play a hand-drawn pinball table whose physics is worked out in real units, then pull it apart. Why does the ball float up a table tilted only 6.5°? Why does the tip of a flipper hit hardest? Why do rubber posts bounce the ball back faster than plastic targets? Each answer is a core piece of mechanics.
- Ages
- 11–16 (grades 6–10)
- Time
- 50 minutes
- Subject
- Physics: slopes, levers, energy and collisions
- You need
- Devices with a browser (one per pair), calculators, a ruler and a marble or ball bearing, a protractor and books to make a gentle ramp, a selection of balls to drop
Open Notebook Pinball Jump to the quiz
Learning objectives
By the end of the lesson, students can:
- Explain that on a slope only part of gravity acts along the surface, and calculate it as g × sin θ.
- Explain why points further from a lever’s pivot move faster (v = ω × r) and use it to predict where a flipper gives the strongest shot.
- Define the coefficient of restitution and use it to compare bounces from different materials.
- Describe the energy transfers as a ball is launched, climbs the table, bounces and drains.
Key vocabulary
- Component of a force
- The part of a force that acts in a particular direction. On a slope, gravity splits into a part along the slope and a part into the surface.
- Lever and pivot
- A rigid bar that turns about a fixed point. A flipper is a lever pivoting at its base.
- Angular speed (ω)
- How fast something turns, in radians per second. Each point on a turning flipper moves at v = ω × r.
- Coefficient of restitution (e)
- The fraction of the approach speed that is given back after a bounce. 1 is a perfect bounce, 0 is no bounce.
- Kinetic energy
- Energy of movement: ½mv². A ball moving twice as fast has four times the kinetic energy.
- Gravitational potential energy
- Energy stored by height: mgh. The ball gains it as it climbs the sloping table.
Background for the teacher
A pinball playfield slopes up at about 6.5°. Gravity pulls straight down at 9.81 m/s², but the ball, held against the glass-covered table, only feels the component along the surface: g × sin 6.5° ≈ 1.11 m/s², about a ninth of free fall. That is why a ball seems to float up the table and hang at the top of a shot; sliding 1 m down from rest would take about 1.3 s (a little longer when the ball also has to spin up as it rolls) rather than 0.45 s for a 1 m free fall. The ball is a 27 mm, 80 g steel sphere, as in real machines.
A flipper is a lever. When the coil fires it swings about 55° in roughly 27 ms, reaching about 48 rad/s. The tip, 76 mm from the pivot, moves at 48 × 0.076 ≈ 3.6 m/s; a point halfway along moves at about 1.8 m/s; the pivot hardly moves. That is why a ball struck near the tip flies and one near the base dribbles away. A ball at 3.6 m/s carries ½ × 0.08 × 3.6² ≈ 0.52 J. Each surface has its own coefficient of restitution: rubber posts and slingshots about 0.8, steel rails about 0.5, plastic drop targets about 0.35, so the fraction of kinetic energy kept per bounce is e² (64%, 25% and 12%). The game uses 120 steps a second with sub-steps and continuous collision detection, plus Coulomb friction, rolling resistance and air drag.
Warm-up (5 minutes)
- Hold a marble at the top of a ramp made from a ruler on a single book, then on a stack of three books. Ask: “Why does it roll faster on the steeper ramp, when gravity is the same?”
- Ask: “If you push a door near the hinge or near the handle with the same turning speed, which part moves faster?” Link to the idea of a lever.
Activity with the game
- Pairs open Notebook Pinball and play one game: hold Space (or the launch button) to pull the plunger, let go to launch, and use Left/Z and Right// (or tap the two halves of the screen) for the flippers. Note anything that looks different from a ball rolling on a real table.
- Slope: calculate g × sin 6.5° and compare with a ball dropping straight down. Pupils then make a real ruler ramp at 6.5° (use a protractor) and time a marble rolling 30 cm, comparing with a steeper ramp.
- Flipper experiment in the game: cradle the ball by holding a flipper up until it rests in the crook, then let it roll down the flipper and flip at different moments, so it is hit near the pivot, halfway and near the tip. Record roughly how far up the table each shot goes.
- Calculate the flipper speed at r = 19 mm, 38 mm and 76 mm from the pivot using v = ω × r with ω = 48 rad/s. Does the pattern match the shots?
- Bounce test, real version: drop a rubber ball, a steel ball bearing (onto a hard surface) and a ball of modelling clay from 1 m, and measure the rebound height. Find e = √(rebound height ÷ drop height) for each and compare with the game’s 0.8, 0.5 and 0.35.
- Finish with a game aimed at the missions: skill shot, ramp, drop targets. Pupils explain one successful shot using at least two of the ideas from the lesson.
Discussion questions
- Why does a pinball seem to hang at the top of the table?
Show a model answer
Only g × sin 6.5°, about 1.1 m/s², slows it as it climbs. With such a small deceleration it loses speed slowly, so near the top it is moving slowly for a long time before rolling back.- Why does a ball struck near the flipper tip go further?
Show a model answer
The whole flipper turns at the same angular speed, but the tip is furthest from the pivot so it moves fastest (v = ω × r). A faster surface gives the ball more speed and much more kinetic energy.- Where does the ball’s energy go as a game goes on?
Show a model answer
The plunger’s spring gives it kinetic energy, which turns into potential energy as it climbs and back again as it falls. Each bounce, friction and air drag transfer some to heat and sound, which is why the flippers and bumpers have to keep adding energy.- Why do the rubber slingshots send the ball away faster than the plastic targets?
Show a model answer
Rubber has a higher coefficient of restitution (about 0.8 against 0.35), so it gives back more of the ball’s speed. Pop bumpers and slingshots also kick the ball actively with a coil.- Why was pinball banned in New York City until 1976?
Show a model answer
It was treated as a game of chance, a form of gambling. Roger Sharpe called a shot in front of the city council and made it, helping to show that it takes skill.
Common misconceptions
- On a slope, gravity is weaker.
- Gravity is the same. Only part of it (the component along the slope, g × sin θ) can speed the ball along the surface; the rest presses it into the table.
- Every part of a turning flipper moves at the same speed.
- Every part turns through the same angle in the same time, but points further from the pivot travel further, so they move faster.
- A bouncing ball keeps all its energy if the surface is hard.
- No real bounce is perfect. Some energy always goes into sound, heat and deforming the materials, so e is always less than 1.
Quick quiz
A pinball table slopes at 6.5°. About what acceleration does the ball feel along the table?
- 9.81 m/s²
- 4.9 m/s²
- 1.1 m/s²
- 0.1 m/s²
Answer
C. g × sin 6.5° = 9.81 × 0.113 ≈ 1.11 m/s².
A flipper turns at 48 rad/s. How fast does a point 50 mm from the pivot move?
- 0.96 m/s
- 2.4 m/s
- 24 m/s
- 48 m/s
Answer
B. v = ω × r = 48 × 0.050 = 2.4 m/s.
A ball hits a rubber post at 2.0 m/s with e = 0.8. How fast does it bounce off?
- 0.8 m/s
- 1.6 m/s
- 2.0 m/s
- 2.5 m/s
Answer
B. Rebound speed = e × approach speed = 0.8 × 2.0 = 1.6 m/s.
If a pinball’s speed doubles, its kinetic energy…
- Stays the same
- Doubles
- Triples
- Quadruples
Answer
D. Kinetic energy is ½mv², so doubling v multiplies it by 2² = 4.
Which material in the game gives the least bouncy collision?
- Rubber posts (0.8)
- Steel rails (0.5)
- Plastic drop targets (0.35)
- They are all the same
Answer
C. The plastic targets have the lowest coefficient of restitution, so they return the smallest fraction of speed.
What is the energy store in the plunger before launch?
- Kinetic
- Elastic potential
- Chemical
- Nuclear
Answer
B. Pulling back the plunger compresses a spring, storing elastic potential energy that becomes the ball’s kinetic energy.
Going further
- Use the inclined plane calculator to find the acceleration on slopes of 3°, 6.5° and 10°. How would a steeper table change the game?
- Use the kinetic energy calculator to compare a pinball at 3.6 m/s with a 160 g cricket ball bowled at 35 m/s.
- Research the moment of a force and explain why the flipper coil is attached close to the pivot, using the idea of a lever trading force for speed.
Calculators for this lesson
Curriculum links
- England National Curriculum, KS2 Year 5 Science, Forces: recognise that some mechanisms, including levers, pulleys and gears, allow a smaller force to have a greater effect.
- England National Curriculum, KS3 Physics: moment as the turning effect of a force; energy changes and transfers.
- GCSE Physics (AQA, Edexcel, OCR): kinetic energy (½mv²), gravitational potential energy (mgh), elastic potential energy and energy dissipation.
The science in this plan matches the notes and sources under Notebook Pinball. Free to use and adapt for teaching. Ideas or corrections: hello@notebookfun.com.