Pop the Popcorn: lesson plan
Students set off chain reactions in a hot pan, then explain two ideas: how heating water inside a sealed kernel builds pressure until it bursts, and how a chain reaction spreads only when each event triggers at least one more.
- Ages
- 11–16 (grades 6–10)
- Time
- 50 minutes
- Subject
- Physics and chemistry: heating, gas pressure and chain reactions
- You need
- Devices with a browser (one per pair), a few unpopped and popped kernels to pass round, optional kitchen scales for a demonstration
Open Pop the Popcorn Jump to the quiz
Learning objectives
By the end of the lesson, students can:
- Explain why a popcorn kernel bursts, using the ideas of heating, evaporation and gas pressure inside a sealed container.
- State that a kernel pops at about 180 °C, when the steam pressure inside reaches roughly 9 atmospheres.
- Describe a chain reaction and explain why it grows, fizzles or stops depending on how many new events each event triggers.
- Use evidence from the game to explain how spacing, butter and old maids change the size of a chain.
Key vocabulary
- Pressure
- Force per unit area. Gas pressure comes from molecules hitting the walls of their container. 1 atmosphere is about 101 kPa.
- Evaporation and boiling
- Liquid water turning into water vapour (steam). Steam takes up roughly 1,600 times the volume of the same mass of liquid water at normal pressure.
- Hull (pericarp)
- The hard, waterproof outer coat of a popcorn kernel. It traps the steam until it splits.
- Chain reaction
- A process where each event causes one or more further events, so the effect can spread or grow.
- Threshold
- The level something must reach before a change happens, such as the popping temperature of a kernel.
- Old maid
- A kernel that never pops, usually because its hull is cracked or it is too dry to build enough pressure.
Background for the teacher
A popcorn kernel holds starch and about 14% water by mass inside a hard hull. As it heats, the water turns to steam, but the hull will not let it out, so the pressure rises. At about 180 °C the pressure inside reaches roughly 9 atmospheres (around 900 kPa) and the hull splits. The superheated starch puffs into a foam 30–40 times the kernel’s volume and sets as it cools. In 2015 Virot and Ponomarenko filmed kernels at 2,900 frames per second and found that a kernel jumps when a leg of starch pushes off the pan, and that the pop is the sound of escaping steam.
The game turns this into a chain reaction. The pan holds every kernel just below its own popping threshold (each one is slightly different). A pop releases heat that falls off with distance, so only close neighbours get hot enough to pop. Buttery kernels pass on about 70% more heat and reach about 60% further, and old maids never pop, so they block the chain. Levels start with 80 kernels and one tap, and grow to 240 kernels, three taps and goals of up to 92%. A chain keeps going only while each pop sets off, on average, at least one more: the same idea that governs nuclear fission, forest fires and the spread of disease (the reproduction number R).
Warm-up (5 minutes)
- Pass round unpopped and popped kernels. Ask: “Where did all that extra size come from? What was inside the kernel?”
- Ask: “Why does a sealed crisp packet puff up in a hot car, and what would happen if it got hotter and hotter?”
- Show a line of dominoes (or a photo) and ask: “What has to be true for one push to knock them all over?”
Activity with the game
- Pairs open Pop the Popcorn and play level 1. Tap one kernel and watch. Record the percentage popped and the longest chain shown on the end card.
- Replay level 1 three times, tapping a kernel at the edge of the pan, one in a sparse patch and one in the densest part. Record the result each time and decide which gives the biggest chain and why.
- Play on to the two-tap levels (level 4 onwards). Before each tap, pairs mark where they plan to tap and predict the percentage that will pop. Compare prediction with result.
- From level 5, butter appears. Pairs compare chains that start near butter with chains that do not, and explain the difference using the word heat.
- Spot the old maids (the dark kernels). Pairs describe what happens to a chain that meets a cluster of them, and link it to the real reason kernels fail to pop.
- Regroup: build a class table of tap position, number of neighbours nearby and kernels popped. Discuss what makes a chain grow or die out.
Discussion questions
- Why does a kernel need a hard, waterproof hull to pop?
Show a model answer
The hull traps the steam. Without it, water vapour would leak out as it formed, the pressure would never build up, and the kernel would just dry out. That is exactly what happens to old maids with cracked hulls.- Why does the pressure inside rise as the kernel gets hotter?
Show a model answer
More water turns to steam, and the steam molecules move faster, hitting the inside of the hull harder and more often. In a fixed volume, a hotter gas exerts more pressure, until the hull cannot hold it.- Why do some taps clear the pan while others fizzle out?
Show a model answer
A chain keeps going only if each pop heats at least one neighbour past its threshold. In a dense patch each pop has many close neighbours, so the chain spreads. At the edge or in a sparse patch, the heat reaches too few kernels and the chain dies.- How is a nuclear chain reaction like this game?
Show a model answer
In fission, each splitting uranium nucleus releases neutrons that can split other nuclei. If on average more than one new split follows each split, the reaction grows. Reactors use control rods to absorb neutrons, much as old maids absorb heat here.- Why do popcorn makers carefully control the moisture in kernels?
Show a model answer
Too little water and there is not enough steam to burst the hull; too much and the popcorn comes out small and chewy. Around 14% gives the biggest, fluffiest popcorn.
Common misconceptions
- Popcorn pops because the hull cracks from the heat.
- Heat alone does not crack it. The steam pressure inside, around 9 atmospheres, bursts the hull from within.
- In a chain reaction, every event must trigger many more.
- It only needs to trigger at least one on average. Slightly more than one makes it grow; slightly less makes it die out.
Quick quiz
At about what temperature does popcorn pop?
- 50 °C
- 100 °C
- 180 °C
- 500 °C
Answer
C. At about 180 °C the steam pressure inside reaches roughly 9 atmospheres and the hull bursts.
What builds up the pressure inside a kernel?
- Air leaking in
- Steam from the water inside
- Oil from the pan
- Carbon dioxide from burning
Answer
B. About 14% of the kernel is water, which turns to steam that cannot escape the hull.
Roughly how much does popped starch expand?
- 2 times
- 5 times
- 30–40 times
- 1,000 times
Answer
C. The starch foam takes up about 30 to 40 times the volume of the original kernel.
In the game, where is the best place to tap?
- At the very edge
- Among the old maids
- In the densest part of the pan
- It makes no difference
Answer
C. Heat falls off with distance, so a pop with many close neighbours triggers the most new pops.
A chain reaction keeps growing when each event triggers, on average…
- exactly zero events
- less than one event
- more than one event
- exactly one event, then stops
Answer
C. More than one new event per event makes the reaction grow; less than one and it dies away.
Why do old maids fail to pop?
- They are too heavy
- Their hull is cracked or they are too dry
- They are a different colour
- They are too cold
Answer
B. Steam leaks out of a cracked hull, or there is too little water to make enough pressure.
Going further
- Demonstration: weigh 50 g of kernels, pop them in a microwave bag, cool and weigh again. The mass lost is mostly water that escaped as steam; work out the percentage.
- Calculate: use the ideal gas law calculator to see how pressure in a fixed volume changes when the temperature rises from 20 °C to 180 °C (remember to use kelvin).
- Research: how do firebreaks stop forest fires, and how do control rods keep a nuclear reactor steady? Explain both using the idea of a chain reaction.
Calculators for this lesson
Curriculum links
- NGSS MS-PS1-4: develop a model that predicts and describes changes in particle motion, temperature, and state of a pure substance when thermal energy is added or removed.
- England National Curriculum, KS3 Physics: the differences in arrangements, in motion and in closeness of particles explaining changes of state.
- GCSE Physics (England): particle model of matter, including how increasing the temperature of a gas at constant volume increases its pressure.
The science in this plan matches the notes and sources under Pop the Popcorn. Free to use and adapt for teaching. Ideas or corrections: hello@notebookfun.com.