Make Sand Sing: lesson plan
Pupils tune a virtual brass plate covered in sand until it rings, then watch the sand gather on the lines that do not move. Counting those lines against the note’s frequency reveals the rule behind every musical instrument: higher notes divide a vibrating object into more, smaller pieces.
- Ages
- 10–16 (grades 5–10)
- Time
- 50 minutes
- Subject
- Physics: sound, vibration, resonance and standing waves
- You need
- Devices with a browser and sound (one per pair, headphones help), optional: a speaker or drum, cling film, a bowl and dry rice or salt for a real demonstration
Open Make Sand Sing Jump to the quiz
Learning objectives
By the end of the lesson, students can:
- Explain that sounds are made by vibrating objects and that frequency, measured in hertz (Hz), sets the pitch.
- Describe resonance: an object vibrates strongly only at certain natural frequencies.
- Identify nodes (still points or lines) and antinodes (places of greatest movement) in a standing wave pattern.
- Use evidence from the game to state a pattern linking the number of nodal lines to the frequency.
Key vocabulary
- Vibration
- A rapid back-and-forth movement. All sounds start with something vibrating.
- Frequency
- The number of vibrations per second, in hertz (Hz). Higher frequency means higher pitch.
- Resonance
- A large vibration that builds up when something is driven at one of its natural frequencies.
- Standing wave
- A vibration pattern that stays in place, with some parts moving a lot and some not at all.
- Node / nodal line
- A point or line in a standing wave that stays still. On a Chladni plate the sand collects there.
- Antinode
- A place in a standing wave that moves the most. Sand is thrown off these areas.
Background for the teacher
A plate, string or drum skin can vibrate in many patterns, called modes, each with its own natural frequency. Drive it at one of those frequencies and the small pushes add up (resonance), so it rings loudly; between them it barely responds. In each mode the plate divides into patches moving up and down in opposite directions, separated by nodal lines that stay still. Sand on moving patches is bounced into the air and lands somewhere slightly different; sand that lands on a nodal line stays. After a few seconds the sand draws the vibration.
Ernst Chladni published these figures in 1787, stroking a centre-clamped brass plate with a violin bow. Napoleon saw them in 1808 and funded a prize for the theory, won in 1816 by Sophie Germain. In the game there are 16 resonances on the square plate, from 104 Hz to 2,314 Hz (scaled to fit one ruler, but in the right order), then 16 more on a round plate. The square figures follow cos(nπx)·cos(mπy) ± cos(mπx)·cos(nπy), with pitch rising with n² + m²; on round plates, Chladni’s law says pitch rises roughly with the square of (diameters + 2 × circles). Real 20–30 cm brass plates resonate from around a hundred hertz to several thousand. Violin makers still use the method to tune carved plates.
Warm-up (5 minutes)
- Pupils rest fingers on their throat and hum a low note, then a high one. What do they feel? Introduce the idea that sound is vibration and pitch is how fast it vibrates.
- Ask: “When you push someone on a swing, how do you make them go higher with small pushes?” (Push in time with the swing.) This is resonance.
Activity with the game
- Pairs open Make Sand Sing. Slide the brass pointer slowly along the ruler and drag the violin bow to keep the plate ringing. Notice that most notes only make the sand shiver.
- Find the first resonance: when the pointer clicks into place and the sand rushes into a figure, hold it there until the figure is traced into the sketchbook. Record the frequency (shown on the ruler) and sketch the figure.
- Keep hunting. For each new figure, record the frequency and count the nodal lines (or for complex figures, the number of separate moving patches). Aim for at least six figures, spread across low, middle and high notes.
- Pairs plot frequency against number of patches (or lines) and write a one-sentence rule. Then use it to predict roughly where on the ruler a more complicated figure might be, and test the prediction.
- Fill the sketchbook (or ask for a hint by tapping an empty page) to open the round plate. Count diameters and circles in each figure and check whether rings raise the note more than spokes, as Chladni’s law predicts.
- Optional real demo: stretch cling film over a bowl, sprinkle rice or salt on it, and hold a speaker playing a steady tone near it (or tap a drum). Change the pitch and watch the patterns change.
Discussion questions
- Why does the sand only move strongly at certain notes?
Show a model answer
The plate has natural frequencies. At those, each push from the bow arrives in step with the plate’s own motion and the vibration builds up (resonance). At other frequencies the pushes are out of step and mostly cancel.- Why does the sand end up on the lines, not on the parts that move?
Show a model answer
Moving parts throw the grains into the air and they land a little way off. Grains that land on a nodal line are not thrown again, so over time almost all the sand collects there.- What pattern did you find between the figure and the frequency?
Show a model answer
Higher frequencies give more nodal lines and more, smaller patches. Smaller patches have to move back and forth faster, which means a higher note.- Why does every figure in the game have a line through the middle?
Show a model answer
The plate is clamped at the centre by a bolt, as Chladni’s were, so the centre cannot move. It is forced to be a node in every mode.- How do violin and guitar makers use this?
Show a model answer
They vibrate an unassembled carved top or back with a loudspeaker and sprinkle fine particles on it, then shave the wood until the expected figures appear at the right frequencies. Carleen Hutchins developed this into free-plate tuning.
Common misconceptions
- Louder sounds are higher in pitch.
- Loudness depends on the size (amplitude) of the vibration; pitch depends on its frequency. A note can be loud and low or quiet and high.
- The sand moves because the sound pushes it around.
- The plate itself moves. Sound in the air is far too weak to move sand; the vibrating metal bounces the grains directly.
- Something vibrating moves everywhere at once.
- In a standing wave some places (nodes) stay completely still while others (antinodes) move a lot.
Quick quiz
What does frequency measure?
- How loud a sound is
- How many vibrations happen each second
- How far sound travels
- How long a sound lasts
Answer
B. Frequency is vibrations per second, measured in hertz (Hz).
On a Chladni plate, where does the sand collect?
- On the antinodes
- At the edges only
- Evenly everywhere
- On the nodal lines
Answer
D. Nodal lines do not move, so sand that lands there stays put.
What is resonance?
- A large vibration when something is driven at its natural frequency
- A sound bouncing off a wall
- Sound travelling through a solid
- A very quiet hum
Answer
A. Driving at a natural frequency adds energy in step with the motion, so the amplitude grows.
Figure A appears at 200 Hz and figure B at 1,600 Hz. Which probably has more nodal lines?
- A
- B
- They have the same
- You cannot tell anything
Answer
B. Higher-frequency modes divide the plate into more, smaller patches, so more nodal lines.
Who won the French Academy’s prize in 1816 for a theory of vibrating plates?
- Ernst Chladni
- Isaac Newton
- Sophie Germain
- Napoleon Bonaparte
Answer
C. Sophie Germain, largely self-taught, became the first woman to win a prize from the Paris Academy of Sciences.
A note of 440 Hz in air (sound speed 343 m/s) has what wavelength?
- About 0.78 m
- About 1.28 m
- About 7.8 m
- About 151 m
Answer
A. λ = v ÷ f = 343 ÷ 440 ≈ 0.78 m.
Going further
- Teacher demonstration: if your department has a signal generator and vibration generator, run a real Chladni plate with fine salt, or a vibrating string showing nodes at 1, 2 and 3 loops.
- Use the frequency and wavelength calculator to find the wavelength in air of the lowest (104 Hz) and highest (2,314 Hz) notes in the game.
- Research cymatics or Sophie Germain and present one page: what problem she solved, and why women were barred from the École Polytechnique at the time.
Calculators for this lesson
Curriculum links
- England National Curriculum, KS2 Year 4 Science, Sound: identify how sounds are made, associating some of them with something vibrating; find patterns between the pitch of a sound and features of the object that produced it.
- England National Curriculum, KS3 Physics, Waves: frequencies of sound waves, measured in hertz (Hz); sound produced by vibrations of objects.
- NGSS MS-PS4-1: use mathematical representations to describe a simple model for waves that includes how the amplitude of a wave is related to the energy in a wave.
The science in this plan matches the notes and sources under Make Sand Sing. Free to use and adapt for teaching. Ideas or corrections: hello@notebookfun.com.